Echo EDR-2100 Drill User Manual


 
8
IMPORTANT
Stored fuel ages. Do not mix more fuel
than you expect to use in thirty (30)
days, ninety (90) days when a fuel
stabilizer is added.
Stored two-stroke fuel may separate.
ALWAYS shake fuel container
thoroughly before each use.
On
Stop
Throttle trigger
Air cleaner
Fuel return line
Purge bulb
NOTE
When engine does not stop, shift choke
shutter to close position.
Check and repair stop switch before
starting the engine again.
STARTING COLD ENGINE
STOPPING ENGINE
STARTING WARM ENGINE
Stand the engine upright on a level
surface.
Place ignition switch in ON (START/RUN)
position.
Push purge bulb 3 to 4 times (or until fuel is
visible in fuel return line).
Shift choke shutter to close position.
(START)
Open throttle trigger to a fast idle.
Pull recoil starter until the engine fires.
Shift choke shutter to full open position,and
if necessary, start the engine again and
allow to warm up before using.
- The clutch engages at approximatery
3,500 r/min. therfore the cutter may rotate
at fast idle engine speed.
Choke lever
Place ignition switch in ON (START/RUN)
position.
Pull starter handle until the engine fires.
- Do not use the choke.
Set throttle trigger in idle position.
Place ignition switch in STOP position.
(Open)
RUN
START
(Close)
Push