9
• This model is equipped with reverse
rotation mechanism.
• When drilling, set shift lever down to
clockwise (CW) rotation position.
• If bit is locked due to deep penetration
during drilling operation, set shift lever up
to counterclockwise (CCW) rotation
position and operate reversed for easy
pulling-out.
REVERSE ROTATION
• When changing direction of drill rotation,
operate as follows:
- Return engine to idle.
- Engine shift lever to CW or CCW
position with a slight acceleration of
the throttle trigger.
To properly lock the gears in the gears
in the gear case.
- Do not operate shift lever forcibly when
changing rotation direction.
NOTE
Do not shift from forward to reverse (or
vice-versa) while the chuck is turning.
Failure to do so may cause unit damage.
Always release throttle and allow the unit to
return to idle before shifting.
Do not stand close to drill or chuck with
your body or clothes while operation.
When drilling, ensure that no power cable
or other obstacle exist.
WARNING DANGER
• WHEN THE DRILL CAN NOT PULL OUT
FROM THE WOOD, DO NOT TRY TO
PULL OUT THE DRILL BY FORCE.
• WHEN CHANGING THE BIT, ENSURE
TO STOP THE ENGINE.
• AFTER A JOB, BIT AND GEAR CASING
MAY BE HEATED, DO NOT TOUCH
THEM WITH BARE HANDS.
Shift lever
Clockwise
(CW)
Counter
clockwise
(CCW)