Filter
Top Products
C
D
E
13.6 Cutter Guard Setting
Loosen starknob (C) and set holddown
shoe onto the workpiece.
Adjust downward pressure with star-
knob (D).
After loosening starknob (E) set spring
guide against the workpiece.
14.4 Moulding Boards
- Mount tool as per section 13.2.
- Set/check spindle speed as per
section 13.3.
- Adjust spindle and fence as per
sections 13.4 and 13.5.
- Remove the cutter guard's pres-
sure spring.
- Set holddlown shoe as described
in section 13.6.
- Start machine and feed the work-
piece with a steady motion slowly
against the rotating tool.
Caution!
Always feed with a pushstick if the workpiece width is less than 120 mm.
Caution!
Switch machine off and let tool come to a complete stop before making any adjustments.
14.3 Moulding Strips
Important!
Always use a pushblock to feed the
work when near the end.
- Mount tool as per section 13.2.
- Set/check spindle speed as per
section 13.3.
- Adjust spindle and fence as per
sections 13.4 and 13.5.
- Adjust cutter guard as per section
13.6 to accommodate the
workpiece.
- Start machine and feed the work-
piece with a steady motion slowly
against the rotating tool.
14.2 Stock Prechecking
- Grown timber should be planed prior to any moulding operation.
- Do not work stock that is warped, bend or otherwise does not rest fully over its full length on the table and/or
against the fence plates.
14 Operation
14.1 Tools
This spindle moulder model TF 100 M must only be operated with tools having chip limitors for reduced kickback
and approved for manual feed, e.g. BG-TEST tools or equivalent.