Filter
Top Products
14.5 Making Tenons
Tenons and grooves in end grain must only be made with the workpiece firmly held and guided by the sliding
carriage TF 100, available as optional accessory.
To complete the tenon, turn work-
piece over by 180° and make another
pass.
Install table extension according to
the instructions provided. Set tool,
fence and guard as required.
Set the backstop as required. Start machine. Place workpiece on
the table and against the backstop,
then push forward against the fence
into the rotating tool.
14.5 Set-In Work
15 Care And Maintenance
Always disconnect from power before servicing.
Danger of severe personal injury if machine is started unintentionally.
- Lubricate all moving parts regularly with a few drops of motor oil.
- Clean table and fence plates regularly, keep resin-free.
Start machine. Feed work slowly and
with a steady motion against the rota-
ting tool. When the pass is completed
pull the sliding carriage back to its
starting position.
Place workpiece on the sliding carria-
ge's table and secure with the clam-
ping arm. Lower the holddown shoe
as much as possible to cover the
space between the fence plates above
the tool.