Epson 50-764 Dust Collector User Manual


 
9-English
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
CASTERS
1. Turn stand (A) upside down, as shown in Fig 1F.
2. Align holes in caster assembly (B) with holes in
plates on stand. Place small 5/16” flatwasher on a
5/16”x3/4” hex head screw. Insert screw through
hole in caster assembly and thread into hole in
stand. Repeat for all holes in all casters.
3. Tighten hardware by hand, then set with a 12mm
wrench.
LEGS TO MOTOR/BLOWER
ASSEMBLY
1. Place motor/blower assembly with the motor down.
(Fig. 2)
2. Place 3/8” (18 mm) flatwasher on knob (A) Fig. 2.
3. Align holes (B) on legs with holes (C) in the mo-
tor/blower assembly. Legs should extend up. Insert
knob through hole (B) in the legs and thread into
hole (C) in the motor/blower assembly. Tighten
knob securely.
4. Repeat steps for all knobs on both legs.
Fig. 1F
Fig. 2
ATTACHING STAND TO LEGS ON
MOTOR/BLOWER ASSEMBLY
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
Place all four stand posts (A) Fig. 3 into four legs (B) on
motor/blower assembly.
Fig. 3
A
B
D
C
B
A
THIS MACHINE IS HEAVY. USE TWO
OR MORE PEOPLE WHEN LIFTING.
C
C
A
B