Filter
Top Products
English
10
5. Turn the Rack ‘N Pinion adjustment knob (L) located to the right
of the wall mount to move the laser level up and down to set
your height. Use the wall mount measuring scale to pinpoint
your mark.
NOTE: It may be helpful to turn the power on and turn the rotary
head so that it puts a dot on one of the laser scales. The
D
EWALT target card is marked at 1-1/2" (38mm), therefore, it
may be easiest to set the offset of the laser to 1-1/2" (38mm)
below the wall angle.
6. Once you have positioned the
laser at the desired offset height,
tighten the Rack ‘N Pinion
locking knob to maintain the
offset.
7. Using the base leveling knob
(M), approximate a level position
from the wall.
Laser Accessories
Recommended accessories for use with your tool are available for
purchase at your factory-owned local service center.
CAUTION: The use of any non-recommended accessory may
be hazardous. Use only D
E
WALT accessories designed for use
with this product.
If you need any assistance in locating any accessory, please con-
tact D
EWALT Industrial Tool Co., 701 East Joppa Road, Baltimore,
MD 21286 or call 1-800-4-D
EWALT (1-800-433-9258). See our
catalog on the World Wide Web at www.dewalt.com.
Digital Laser Detector: DW0772
Some laser kits include a DEWALT digital laser detector. The
D
EWALT digital laser detector allows you to locate a laser beam
emitted by a rotary laser in bright light conditions or over long dis-
tances. The detector can be used in both indoor and outdoor situ-
ations where it is difficult to see the laser beam. The detector is not
M
for use with non-rotating lasers but is compatible with most rotary
red-beam or infra-red (invisible) beam lasers on the market. It can
be set to indicate the location of the beam to either the nearest 1/8"
or the nearest 1/25". The detector gives both visual signals through
the display window (N) and audio signals through the speaker (O)
to indicate the location of the laser beam.
The D
EWALT digital laser detector can be used with or without the
detector clamp. When used with the clamp, the detector can be
positioned on a grade rod, leveling pole, stud or post.
BATTERIES
The digital laser detector is powered by a 9 volt battery. To install
the battery provided, lift up on the battery compartment cover (P).
Place the 9 volt battery in the compartment, aligning the battery
as shown on the embossed icon (Q).
DETECTOR CONTROLS
The detector is controlled by the power/volume button (R) and the
accuracy mode button (S). When the power/volume button is
pushed once, the detector is turned on. The top of the display win-
X
N
R
S
O
P
Y