Filter
Top Products
12
6. After adjusting, tighten the four screws located in holes (N) Fig. 12 of the front table board (A).
7. Insert four 1/4-20 x 1-1/4" round-head screws (P) Fig. 12 in the holes (R) Figs. 11 and 12 of the table board. Tighten
each of the screws until each corner of the table board raises approximately 1/8".
8. Loosen the bevel clamp lever (S) Fig. 14, pull out the bevel index knob (T), and rotate the motor (V) to the vertical
position until the bevel index engages. Tighten the bevel clamp lever (S).
NOTE: If the motor shaft contacts the table board before the motor is fully rotated, raise the track arm (X) Fig. 15 by turning the
elevating handle (C).
9. Loosen the cuttinghead clamp knob (W) Fig. 15. Move the cuttinghead to the front of the track arm (X). Tighten the
cuttinghead clamp knob (W).
10. Loosen the track arm clamp handle (Y) Fig. 15.
NOTE: The track arm clamp handle (Y) Fig. 15 has left-handed threads. Press down on the indexing release handle (Z) Fig.
15, and pivot the track arm (X) to the left until the motor shaft (B) Fig. 16 is near the front left adjustment screw (P) Fig. 13 of
table board (C) Fig. 13. Tighten the track arm clamp handle (Y) Fig. 15.
Fig. 12
C
N
R
R
N
Fig. 13
Fig. 14
Fig. 15
P
R
X
W
V
T
S
X
W
Y
C
Z
Fig. 16
D
B
P
A
C
11. Place an arbor wrench (D) Fig.16 between the table
board (A) and the motor shaft (B). Lower the track arm
(X) Fig. 15 by turning the elevating handle (C) counter-
clockwise until the motor shaft (B) Fig. 16 touches the
arbor wrench.