Filter
Top Products
13
en
MULTIMASTER FMM250 (Figure 4).
Before mounting or replacing
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of injuries
through accidental starting of the power tool.
For all work or when changing
application tools, always wear
protective gloves. Danger of injury from the
sharp edges of the application tools. Applica-
tion tools can become very hot while work-
ing. Danger of burns!
➤Unscrew the clamping screw.
➤Clean the tool holder, the application
tool and the clamping screw.
➤Place the application tool exactly onto
the star-shaped tool holder. Pay atten-
tion that the application tool has a flush
fit.
➤Tighten the clamping screw using the
supplied Allen key.
Attaching/replacing the sanding sheet (Figure 5).
➤Align the sanding sheet and press it
onto the sanding plate by hand.
➤Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and prevents
premature wear.
The sanding sheet can be pulled off again and
then remounted offset by 120° when only
one tip of the sanding sheet is worn.
WARNING
CAUTION
Clamping screw
Allen key
Tool holder
Fig. 4
Sanding
pad
Sanding
sheet
Fig. 5
3 41 01 091 21 0.book Seite 13 Montag, 29. Juni 2009 8:32 08