Filter
Top Products
7
en
Extension cord
If the use of an extension cable
is required, its length and con-
ductor cross-section must be adequate for the
applicational case, in order to prevent a volt-
age drop in the extension cable, power loss and
overheating of the power tool. Otherwise, the
extension cable and power tool are liable to
electrical danger, and the working efficiency is
impaired.
Recommended dimensions of extension cords
at an operating voltage of 120 V – single-phase
a. c., with only one power tool FMM250/
FMM250Q connected:
Intended use of the power tool.
This power tool is intended for commercial
or private use for dry sanding of small sur-
faces, corners and edges, for scraping, for
sawing thin steel sheet, wood and plastic
components using the application tools and
accessories recommended by FEIN.
With the respective accessories, the power
tool can also be used for polishing, cutting,
separating and as a rasp.
Operation of the power tool off power generators.
Operate the power tool only off
a.c. generators with sufficient power
output that do not have any distortion of the
voltage curve.
Operating the power tool off
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
WARNING
Cord Size in A.W.G. Wire Sizes in mm
2
18 16 14 0.75 1.5 2.5
Cord Length in Feet Cord Length in Meters
25 100 150 30 60 120
WARNING
3 41 01 091 21 0.book Seite 7 Montag, 29. Juni 2009 8:32 08