Filter
Top Products
4
– Secure the tape measure clamp towards
the end of the tape measure by tightening
the rotary knob (7.4).
2.6 Support plate
The support plate (1.4) is used to support
longer workpieces.
8
8.38.1 8.2
8.5
8.4
– Screw the rotary knob (8.5) through the
recess (8.4) and into the slot nut (8.1) in
the slot (8.2) on the stop profi le to secure
the support plate. Note: The two cams
(8.3) must slot into the groove (8.2).
–If necessary, extend the telescopic section
of the trimming attachment 4 in. to insert
the support plate into the groove.
2.7 Support
The support (1.3) is used to support taller
workpieces.
9
9.1 9.2
9.3
– Unscrew the rotary knob (9.1) that clamps
the support.
– Insert the slot nut (9.3) into the top slot
(9.2) on the stop profi le or the adjustable
spacer.
–If necessary, extend the telescopic section
of the trimming attachment 4 in. to insert
the support plate into the groove.
– Slide the support to the required positi-
on.
– Tighten the rotary knob (9.1) to secure the
support.
2.8 Stop fl ag
The stop fl ag (1.5) is used to adjust the
distance between the saw blade and the
workpiece so that the workpiece is cut to
the required length.
– Unscrew the rotary knob (1.11) on the
adjustable spacer.
– Move the stop profi le (1.1) and the spacer
(1.6) approx. 3.1 in. apart.
10
10.1 10.2
10.3
10.4
– Unscrew the rotary knob (10.1) that clamps
the stop fl ag.
– Insert the slot nut (10.3) into the top slot
(10.2) on the stop profi le or the adjustable
spacer.
– Slide the stop fl ag to the required positi-
on.
– Tighten the rotary knob (10.1) to secure
the stop fl ag.
Adjusting play on the stop fl ag
– Turn (tighten or unscrew) the two screws
(10.4) until the stop fl ag moves smoothly
along the slot, but without play.
3 Adjustments
3.1 Tape measure
The tape measure starts at 11.81 in./
30 cm so that it does not come into con-
tact with the saw blade. Therefore, make
sure that the distance between the tape
measure and the saw blade is correct: