Fujitsu MHD2021AT Drill User Manual


 
2.2 System Configuration
C141-E050-02EN 2-5
2.2.3 2 drives connection
MHC2032AT
MHC2040AT
MHC2032AT
MHC2040AT
(Host adaptor)
Note:
When the drive that is not conformed to ATA is connected to the disk drive above
configuration, the operation is not guaranteed.
Figure 2.4 2 drives configuration
HA (host adaptor) consists of address decoder, driver, and receiver.
ATA is an abbreviation of AT attachment. The disk drive is
conformed to the ATA-3 interface.
At high speed data transfer (PIO mode 3, mode 4, or DMA mode 2
U-DMA mode 2), occurence of ringing or crosstalk of the signal
lines (AT bus) between the HA and the disk drive may be a great
cause of the obstruction of system reliability. Thus, it is necessary
that the capacitance of the signal lines including the HA and cable
does not exceed the ATA-3 standard, and the cable length between
the HA and the disk drive should be as short as possible.
No need to push the top cover of the disk drive. If the over-power
worked, the cover could be contacted with the spindle motor. Thus,
that could be made it the cause of failure.
MHC2032AT
MHC2040AT
MHD2021AT
MHD2032AT
MHC2032AT
MHC2040AT
MHD2021AT
MHD2032AT