Filter
Top Products
11
Displays During Charge
ScrEEn DisplAys
CHG 0.30:25 00000
NC + 3.00A 5.200V
“BLC” will be shown if the balancer cable of the battery is connected to the
balancing port of the charger.
CHG: Charge
NC = NiCd
NM = NiMH
Ll = Lilo, LP = LiPo, LF = LiFe
Pb = Pb
If the Enter button is pressed at any
stage, the charge can be terminated.
END 030:00 00000
NC 100mA 10.750V
In order to move to the main display, press the Enter button.
Completion Display (with Audible Warning)
If the Battery TYPE button is pressed for over 3 seconds, the Data view will be
displayed as above. Data displays can be scrolled left and right by using the INC &
DEC buttons. If the Battery TYPE button is pressed again, the data view screen will
disappear.
This screen only shows a value if a balancing adaptor is
connected.
Press the ENTER button, the “01” should flash, each cell voltage
is shown by INC & DEC buttons.
LCB-MAX = 0.000V
LCB-MIN = 0.000V
This screen only shows a value if a balancing connector is
connected.
It shows the maximum and minimum voltage on the screen.
Data Display
In order to move to the main display, press the Enter button.
INPUT = 12.00V
OUTPUT = 13.18V
ChgCAPA=00000mAh
CHG PEAK = 12.00V
INC
DEC
CHG PEAK = 12.00V
DCHG AVR = 13.18V
INC
DEC
LCB-[01] = 0.000V
LCB-AVG = 0.000V
INC
DEC
ENTER
LCB-[02] = 0.000V
LCB-AVG = 0.000V
INC
DEC
0.00 0.00 0.00V
0.00 0.00 0.00V
LCB-MAX = 0.000V
LCB-MIN = 0.000V
INC
DEC
INC
DEC
INC
DEC
LCB-[01] = 0.000V
LCB-AVG = 0.000V