Filter
Top Products
SAFETY FEATURES
Safe-T-Beam® (STB) Non-Contact Reversing System
Puts an invisible beam across the door opening. The door stops
and reverses to the full open position if anything
th
passes
rough the beam. LED indicator lights on the powerhead and
on the STBs provide a self diagnostic code if an operational
problem exists.
Safe-T-Reverse® Contact Reversing System
Automatically stops and reverses a closing door within two
seconds of contact with an object.
Automatic ForceGuard™ Control
Automatically sets the force required to fully open and close the
door for maximum safety.
Watch Dog™ Monitoring System
Monitors the Safe-T-Beam® system to ensure proper function-
ality and will automatically stop and reverse a closing door if a
problem is detected.
Manual Emergency Release
Manually releases door from door opener. Used during a power
failure or other emergency to allow manual opening and closing
of door.
SmartSet™ Electronic Programming
Easily adjust the programming to reduce opening speed to a
desired rate, vary limits and force, and program new remotes.
Automatic Lighting System
Two bulb lighting system supplies up to 200 Watts of light for
safer evening exits and entries. Turns ON when door is activated
and automatically turns OFF 4 minutes later.
Integrated Motion Detection (Not available on all models)
Select units have motion detection built into the powerhead.
Lights automatically turn ON when motion is detected for much
safer movement through the garage. Lights will turn OFF after
4 minutes of no motion.
3
INTELLICODE® 2 Access Security System
A new generation superior encryption system that enhances
the security of the door opener by continuously changing the
access code each time the remote is used. The door opener
esponds to each new code only once.
An access code copied
from a working system and tried again will not control the
door opener.
OPENER FEATURES
Wall Console, Series III
Operates door opener from inside garage. The Wall Console has
an Indicator Light with: Open/Close, Sure-Lock™, and
Independent Light Control buttons.
©2011 The Genie Company
9/2011
r
TRANSMITTER COMPLIANCE STATEMENT
Transmitters comply with all United States and Canadian legal
requirements as of the date of manufacture.
No warranty is made
that they comply with all legal requirements of any other jurisdiction.
If transmitters are to be used in another country, the importer
must determine compliance with any local laws and
which m
regulations
ay differ from United States and Canadian requirements
prior to use.
Los transmisores cumplen con todas las reglamentaciones legales
de los Estados Unidos y del Canadá, en la fecha de fabricación.
Ninguna garantía se da que cumplan con todas las reglamentaciones
legales de
ninguna otra jurisdicción. Si los transmisores se van a
utilizar en otro país, el importador debe determinar si cumplen con
las reglamentaciones y leyes locales que puedan ser diferentes a las
reglamentaciones de los Estados Unidos y del Canadá, antes de usar
los mismos.
Les émetteurs sont conformes à la réglementation américaine et
canadienne à compter de leur date de fabrication.
Aucune garantie
n’est stipulée indiquant qu’ils sont conformes à toutes les
prescriptions juridiques d’autres autorités. Si les émetteurs sont
utilisés dans d’autres pays, il incombe à l’importateur d’en
déterminer leur conformité aux lois et règles locales pouvant
différer de celles des États-Unis et du Canada avant toute utilisation
desdits émetteurs.
Sendegeräte entsprechen allen gesetzlichen Bestimmungen in den
USA und Kanada zum Zeitpunkt der Herstellung. Wir übernehmen
keine Gewährleistung für die Einhaltung aller gesetzlichen
Bestimmungen in anderen Ländern. Sollen Sendegeräte in anderen
Ländern eingesetzt werden, so muss der Importeur
vor dem
Gebrauch sicherstellen, dass die Sendegeräte auch solchen lokalen
Bestimmungen entsprechen, welche von den Bestimmungen der
USA und Kanadas abweichen.
and Car2U® compatible. Refer to the programming
instructions on page 6.
HomeLink®