Filter
Top Products
15
Troubleshooting
Trouble Possible cause Suggested remedy
Fires two nails at time.
The head of the nail is too small
(Head size should be 2.8mm - 3.3mm).
Check nail size.
18 gauge nails have been fitted. Purchase correct size nails from your
local Air Tool supplier.
Nailer skips when driving
brad nails.
Dirt in the nose piece. Drive channel needs to be cleaned.
Dirt or damage prevent nails or pusher
from moving freely in magazine.
Magazine needs to be cleaned.
Inadequate air flow to nailer. The fittings, hose or air compressors
needs to be checked.
Air leaking near the top of
the tool or in trigger area.
Loose screws.
Worn or damaged o-rings or bumper.
Tighten screws.
Nailer runs slow or has
loss of power.
Nailer not lubricated sufficiently. Nailer needs to be lubricated.
Exhaust port in the cap has been blocked. Damaged internal parts needs to be
replaced by an authorized service centre.
Air leaking near the bottom
of the tool.
Loose screws.
Worn or damaged o-rings or bumper.
Tighten screws.
Tool jams frequently.
Incorrect fasteners. Verify approved fasteners of correct size.
Damaged fasteners. Replace with undamaged fasteners.
Magazine is dirty. Clean magazine.
Magazine or nose screw loose. Tighten screws.
WARNING: Disconnect tool from air supply before performing any cleaning and maintenance procedures.