Global Machinery Company MAG950HD Drill User Manual


 
6
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may
arise in connection with the tool’s construction and design:
Damage to the lungs if an effective dust mask is not worn.
Damage to hearing if effective ear defenders are not worn.
Wear goggles
Wear earmuffs
Wear a breathing mask
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Contents of carton
Depth gauge rod
Auxiliary handle
SDS Drill bits
12mm x 160mm
16mm x 210mm
18mm x 210mm
SDS Chisel bits
Point chisel 250mm
Flat chisel 20mm x 250mm
SDS Chuck adaptor
13mm Keyed chuck
Chuck key
Assembly
The Drill is packed, fully assembled.