Filter
Top Products
8
Overview
The cut off saw is used for cutting steel such as pipe, box
section, rectangular, angle iron and steel bars. The saw
can cut at angles from 0° to 45° left and right, it features
a three position fence that permits an extended cutting
range. The quick release vice allows fast adjustment whilst
the lock-off button prevents accidental operation.
Attaching the rubber feet
1. Tilt the saw onto its side.
2. Take the rubber feet and
insert 1 rubber foot into the
matching slots on the base
of the saw (fig A).
3. Ensure the rubber feet are
fully inserted into the slots.
4. Repeat for the other side
and place the chop saw back on its base.
Attaching the vice handle
1. Fit the vice handle onto the end of the vice (fig B).
2. Fit the spring washer over the hex screw followed by
the flat washer.
3. Place the hex screw inside
the vice handle and secure
the vice handle to the vice by
tightening the hex screw in a
clockwise direction (fig C).
4. Fit the cap onto the vice
handle (fig D).
Attaching the rear spark shield
1. Place the spring washer over
the hex bolt followed by the
flat washer (fig E) and then
fit the hex bolt through the
spark deflector. Place the
spark shield in the correct
position (fig F) and tighten
the hex bolt.
2. Tighten the hex bolt to secure
the spark shield in position
(fig G).
A
B
DC
E
G
F