Filter
Top Products
10
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Important information – special product care
Your GMC quick charge screwdriver uses capacitors to
store the energy that operates the screwdriver. Do not
attempt to charge the screwdriver with any other charger
than the one supplied. IT IS DANGEROUS TO USE ANY
OTHER CHARGER TO CHARGE YOUR TOOL. Ensure
you have read all of the safety notes in the previous pages
before using the screwdriver.
Charging
IMPORTANT. Before plugging in the charger (7) into the
mains power supply always ensure that the mains power
switch is turned off.
IMPORTANT. The tool will be fully charged after approximately
45 seconds. The screwdriver can remain in the charger,
with the charger turned on without damage being done to
the cells (Note. Do not leave the screwdriver in the charger
turned on unattended).
1. Place the screwdriver into
the charger (7) vertically with
the bottom of the screwdriver
aligning with the charger as
per the picture shown. Push
the screwdriver down until it
is securely in place.
Note. If the screwdriver is
incorrectly orientated the
screwdriver will not fit securely
in the base.
2. Plug in the charger and switch
on at the power supply. The
power on indicators (10)
will glow signalling that the
charger has power connected
to it. The screwdriver will
now begin charging. While
the screwdriver is charging
the charging indicators (6)
will glow signalling that the
screwdriver is in the charging
process. When the screwdriver
charging process is complete
the charge cycle completed
indicator (5) will glow advising
that the charge cycle has been
completed.
Note. The charge cycle
completed indicator (5) will only
glow when the the screwdriver
charger (7) is plugged in and is
turned on.
The charging time is complete
in 45 seconds.
Note. You may use the screwdriver
at any time. The charging process
does not have to be completed to
use the tool and short chargers
will not harm the tool.
3. The charging time is
approximately 45 seconds.
Once the screwdriver has
completed it’s charge or once
the charge has reached a
suitable level for the task at hand, simply remove the
screwdriver from the charger.
Note. Do not leave the charger turned on and unattended.