Global Machinery Company PFC46V Power Screwdriver User Manual


 
6
Rags, cloths, cord, string and the like should never be left
around the work area.
Support the work properly.
If you are interrupted when operating, complete the
process and switch off before looking up.
Periodically check that all nuts, bolts and other fixings are
properly tightened.
When using the screwdriver, use safety equipment
including safety glasses or shield, ear defenders, and
protective clothing including safety gloves.
Do not charge the screwdriver in a place where static
electricity is generated nor let the battery touch something
that is statically charged.
Take care where the tool is stored. Do not store in areas
of corrosive fumes, or salt air or similar conditions.
Do not dispose of the tool in a fire or put the tool into
a microwave oven, conventional oven, dryer, or high-
pressure container. Under these conditions, the tool
may explode.
Never attempt to open the tool, puncture the casing of
the tool, or subject the tool to strong physical shock. If
the plastic housing of the tool breaks open or cracks,
immediately discontinue its use and do not recharge it.
Stop using the tool if it exhibits abnormal heat, colour or
deformation, or if the tool is in an abnormal condition.
After the tool has reached the end of its useful life,
we recommend recycling the materials at your local
municipal council recycling centre. DO NOT attempt to
replace the capacitor, repair or modify any part of the tool.
When recycling, make it nonconductive by applying
insulating tape to cover the terminals located on the
bottom of the screwdrivers body.
If in doubt, do not plug in the tool. Using a power source with
a voltage less than the nameplate rating is harmful to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may
arise in connection with the tool’s construction and design:
Damage to the lungs if an effective dust mask is not worn.
Damage to hearing if effective ear defenders are not worn.
Additional safety instructions for the charger
Your GMC quick charge screwdriver uses 2 capacitors
to store the energy that operates the screwdriver. Do not
attempt to charge the screwdriver with any other charger
than the one supplied. IT IS DANGEROUS TO USE ANY
OTHER CHARGER TO CHARGE YOUR TOOL.
Do Not attempt to charge any other types of rechargeable
batteries OR non rechargeable battery cells with this charger.
If there is a problem with the charger or the tool, take
it to your nearest Authorised Service centre or phone
and speak with an experienced GMC Customer Service
Representative for assistance in rectifying your problem.
Before using the charger, read all the instructions, labels
and cautionary markings on the charger and screwdriver.