Filter
Top Products
11
To obtain the best life for the tool
The screwdriver should be placed on charge when ever
the tool no longer can perform tasks previously achieved.
Do Not completely run down the charge. DO NOT continue
to use the screwdriver when the charge is exhausted. The
screwdriver does not have automatic spindle lock and using
the screwdriver with no charge may damage the tool.
During operation avoid overloading the screwdriver.
Doing so will allow you to maximise the charge run time.
Avoid allowing loose items like screws or nails etc. to be
stored with tool as these or similar items can short battery
packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Using the screwdriver
Trigger switch
Use the forward/reverse switch
(3) to select the direction of
rotation, then pull the trigger
(4). To stop the drill, release the
trigger switch (4).
Direction of Rotation/Forward
and Reverse
Note. You can only change the
direction of rotation of the drill
using the forward/reverse switch
(3) when the trigger (4) is NOT
depressed.
This switch will allow you to
change the direction of the
motor while the trigger switch
is not depressed.
The forward mode is used for
drilling and tightening screws.
The reverse mode is intended
for the removal of screws and
assisting to remove jammed
drill bits.
Adjusting the handle
The handle can be turned to one of two positions to suit the
task at hand. The tool can be used as a straight handled
screwdriver or as a pistol grip screwdriver.
1. To change the position of the handle, push the handle
adjusting switch (2) in and twist the handle to the
desired position.
2. Release the switch (2) to lock the handle in the new position.