Filter
Top Products
15. Avoid unintentional starting. Always check that the
switch is in the OFF position before plugging in the
tool to the power supply. Do not carry a plugged in
tool with your finger on the switch.
16. Stay alert. Watch what you are doing. Use common
sense. Do not operate a power tool when you are
tired.
17. Check for damaged parts. Before using a tool, check
that there are no damaged parts. If a part is slightly
damaged, carefully determine if it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, proper mounting and any other
conditions that may affect the operation of the tool.
A part that is damaged should be properly repaired or
replaced by an authorised service facility, unless
otherwise indicated in this Instruction Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does
not turn the tool on and off correctly.
18. Guard against electric shock. Prevent body contact
with grounded objects such as water pipes, radiators,
cookers and refrigerator enclosures.
19. Use only approved parts. When servicing, use only
identical replacement parts. Use an authorised service
facility to fit replacement parts.
20. Warning. The use of any accessory or attachment
other than those recommended in this instruction
manual may present a risk of personal injury.
21. Have your tool repaired by a qualified person. This
electric tool is in accordance with the relevant safety
requirements. Repair should only be carried out by
qualified persons using original spare parts, otherwise
this may result in considerable danger to the user.
Additional safety rules for powered router
tables
• Remove the plug from the socket before carrying out
any adjustment, servicing or maintenance
• Use your powered router table on a level and flat stable
surface or firmly clamp or bolt your powered router
table to a workbench. Place the powered router table at
around hip height for maximum convenience and safety
• Fully unwind cable drum extensions to avoid potential
overheating
• When an extension cable is required, you must ensure it
has the right ampere rating for the powered router table
and it is in a safe electrical condition.
• Ensure your mains supply voltage is the same as your
tool rating plate voltage.
• Your tool is double insulated for additional protection
against a possible electrical insulation failure within the
tool.
• Always use the feather boards to help support the work
piece and to guard against kick back.
• Ensure that the lighting is adequate. Keep the area free
of tripping hazards.
• Do not let anyone under 18 years operate this tool.
• After long working periods external metal parts and
accessories could be hot.
• Handle router bits with care, they can be extremely
sharp.
• Check the bit carefully for signs of damage or cracks
before use. Replace damaged or cracked bits
immediately.
• Always use both hands and make sure that you have a
firm grip on the work piece before proceeding with any
work.
• Keep your hands away from the rotating bit
• Make sure that the bit is not in contact with the work
when you switch the machine on.
5