Filter
Top Products
9
Attaching the legs
1. Place the table (1) upside down on a flat surface.
The hole and slots in the table should be furthest
away from you (fig. A).
2. Position the left table leg (2) on the right hand side
and secure to the table using 4 Phillips head screws,
spring washers, flat washers and nuts (fig. B).
3. Position the right table leg (3) on the left hand side
and secure to the table using 4 screws, spring washers,
flat washers and nuts.
4. Turn the table over and set it on its legs.
Attaching the switch box
1. The switch box assembly fits
behind the left leg near the top
of the table.
2. Once the switch box is
installed the on/off switch will
be positioned on the right hand
side of the left leg.
3. An electric cord and an electric
outlet for the router are located
at the rear of the switch box
(fig. C).
4 Place the switch box behind
the left leg.
5. Align the screw holes on the
top of the switch box with the 2
holes at the top of the left leg.
6. Secure the switch box to the leg with the 2 Philips
head screws (fig. D).
7. Move the switch up and down to make sure it
moves freely (fig. E).
Note. The on/off switch features a switch disabling insert for
greater safety when the tool is left unattended. The switch
disabling insert must be in place before using the tool (fig. F).
Securing the table to a work bench
1. Both table legs feature openings at the base of the legs
for securing the router table to a suitable work bench.
2. The work bench should be level and strong enough to
support the weight of the table and the router.
3. The work bench should be very stable to eliminate
vibration when the router is operating.
4. Use appropriate fasteners and bolts to secure the router
table to the work bench.
Attaching the fence to the table
The rear fence (7) is slideable and attaches to the table
through the two channel openings on the table. The infeed
(9) and outfeed (10) fence attach to the rear fence.
1. Position the router table so you are facing the rear of
the table.
2. Align the rear fence (7) over the channel openings in the
table. The large dust extraction port in the fence should
face the rear of the table.
3. Feed the long carriage bolt from the bottom of the table
and insert it through the channel opening in the table and
through the hole on the right side of the fence and through
B
F
A
C
E
D