Filter
Top Products
12
Fitting the magnetic bit holder
Hex head screws, hex bits and magnetic bit holders such
as that supplied as accessories can be fitted into the clutch
of the tool.
When fitting a hex head screw, adjust the driving depth so
that the distance between the underside of the screw head
and the outer rim of the nose piece is 1-1.5mm (to suit the
required degree of tightness).
Insert the end of the hex shaft
of the bit holder (11) into the hex
socket of the clutch housing
of the tool.
Note. Other accessories with
a 6.35mm hex shaft can be
purchased for use with this tool.
Fitting the adjustment collar
and nose cone assembly
WARNING. Ensure that the tool
is switched off and the battery
is removed before changing
accessories or carrying out other
adjustment or maintenance
procedures.
Turn the locking collar (4)
clockwise (viewed from the front)
until it reaches a stop.
Align the marker opening on the
locking collar (4) with the marker
line on the adjustment collar (3).
Note. The slots on the clutch
must line up with the ribs on
the inside of the nose cone
(1). The bayonet projections
on the outside diameter of the
adjustment collar (3) must line
up with the slots in the locking
collar (4).
Push the adjustment collar and
nose cone assembly into the
locking collar.
Turn the locking collar (4) anti-
clockwise (as viewed from the
front) until there is a “click”.
The adjustment collar (3) is then locked in position.
To release, turn it clockwise again.