Filter
Top Products
Storage
18 3A1698F
Cleaning Sprayer Exterior
• Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid.
Do NOT submerge the sprayer.
Fine Finish Tip Wear
• Fine Finish Tip/Guard assembly may require
replacement depending on abrasiveness of paint.
• Do not spray with worn tip. See Troubleshooting,
page 26.
Storage
1. Dilute 4 oz. bottle of Pump Armor Concentrate with
an additional 4 oz. of water in material cup.
2. Thread cup into sprayer, put prime/pressure relief
valve to UP position and squeeze sprayer trigger for
approximately 10 seconds.
3. Reverse spray tip to UNCLOG position, put
prime/pressure relief valve DOWN to spray position,
and aim sprayer into waste area. Pull trigger for 1-2
seconds.
4. Properly dispose of used Pump Armor mixture from
material cup and rinse cup with water.
5. Recharge battery to full charge before storage. See
Charging the Battery, page 8.
6. Store sprayer indoors in a cool, dry place. Store in
an upright position only. Never store sprayer with
material in the cup.
This sprayer is
equipped with a static
wick that reduces the
build-up of static charge
to reduce the risk of fire
and explosion. KEEP
THIS SURFACE
CLEAN OF OVER-
SPRAY.
NOTICE
Failure to store sprayer with Pump Armor will result in
operational problems the next time you spray. Always
circulate Pump Armor through the sprayer after clean-
ing. Water or solvents other than mineral spirits
left in the sprayer will corrode and damage the
pump.
ti16728a
ti16951a
4 oz
ti16729a
ti16700a
ti16716a
ti15425a
ti15418a
ti14991a
ti16701a
ti14991a
ti16716a
ti16726a
ti16730a