Filter
Top Products
Operation
3A2308C 11
5. If yellow light is flashing while triggering, pressure is
set too high. You MUST turn down pressure until
yellow light no longer flashes, increase tip size, or
do not thin material as much.
6. If pressure relief valve is vibrating, pressure is set
too high. You MUST turn down pressure, increase
tip size, or do not thin material as much.
NOTE: Thin materials will generally require a low
setting and thick materials will generally require a
high setting.
IMPORTANT!
After storage, the piston seals need to be energized
prior to next use to prevent leakage. To energize, follow
steps below:
1. Prime system with flushing fluid.
2. Spray at low pressure setting “1” for 10 seconds.
3. Drain fluid. You are now ready to spray.
ti19655a
ti19654a
ti19656a
ti19653a