Filter
Top Products
Operation
3A2308C 7
Operation
Charging the Battery
Batteries are initially 50% charged to provide optimum
battery life and require charging before first use. It takes
approximately 50 minutes to charge a dead battery to
80%, at which point it can be used. It will take approxi-
mately 75 minutes to fully charge a dead battery.
1. Place charger in a dry, well-ventilated area and
away from flammable or combustible materials,
including paints and solvents.
2. Plug charger into an electrical outlet and slide bat-
tery into charger as shown (light will turn on in 5
seconds).
3. When battery becomes fully charged, immediately
unplug the charger from the power supply and
remove the battery from the charger.
NOTE: The amount sprayed with each battery varies
depending on material, spray tip size, battery charge,
and battery temperature. One battery fully charged will
spray up to one gallon. Amount sprayed will be less
depending on spray tip size, material sprayed, life of
battery, temperature, and other environmental factors.
Charger Status Indicator Lights
Replace and charge battery only in a well-ventilated
area and away from flammable or combustible materi-
als, including paints and solvents.
ti19341a
Label Appearance Description
Solid green light Indicates a full charge. Battery can be used.
Flashing green light
Battery is charging, indicates 80% charge.
Battery can be used.
Flashing red light
Battery is charging, indicates less than 80% charge.
Do NOT use battery.
Solid red light
Battery is too hot or too cold to charge. Remove battery and allow to cool or
warm up before charging. Battery temperature must be between
50° F - 113° F (10° C - 45° C) to charge.
Both lights Battery has internal fault or has experienced damage. Do not use.