Filter
Top Products
Repair
34 3A2308C
3. Set motor housing into right half of clamshell and
loosely install two bolts (42) to motor housing as
shown below.
4. Route wires from motor down the handle.
5. Install trigger over top of wires. Route trigger wires
behind trigger.
6. Insert trigger lock over trigger with o-ring facing out.
7. Press ground stud into left half of clamshell. Tighten
nut onto stud. Install ground terminal to stud and
tighten second nut onto stud. Install wire up along
handle.
8. Insert static wick into right half of clamshell and
install left clamshell to right clamshell.
9. Install bolts (42) to motor housing and install screws
(43) to connect clamshell halves. Make sure LED
lights and static wick are securely in place. Tighten
bolts (42) to 50 in-lb (5.6 N•m) and screws (43)
to 9 in-lb (1 N•m).
10. Install pump module to drive module. See Pump
Module/Drive Module, page 31.
ti19629a
42
ti19630a
ti19631a
ti19632a
NOTICE
Wires can become damaged when pinched between
clamshell halves. Make sure no wires are pinched
during reassembly.
ti19633a
ti19634a
ti19635a
43
42