Filter
Top Products
Operation
10 3A2308C
Adjusting Pressure
NOTE: Spraying water, solvents, and thin materials
(low viscosity materials) at high pressure (setting “2” or
higher with yellow light flashing) can result in temporary
pump leaking. To avoid, read and follow instructions
(Quick Guide or Manual) on how to properly adjust
pressure.
NOTE: To reduce overspray and extend battery life,
always spray at lowest pressure that results in an
acceptable spray pattern.
1. Put the pressure relief valve UP to relieve pressure.
2. Turn pressure control knob:
Clockwise to INCREASE pressure, or
Counter-clockwise to DECREASE pressure.
3. Dial in pressure by spraying material on a scrap
material.
4. You MUST start with dial at “1” and gradually
increase by increments of “1” or less until desired
spray pattern is achieved. Put pressure relief handle
in UP position to turn pressure control knob, then
return handle to DOWN position to spray.
ti19372a
ti19347a
0 1 2 3 4 5 6 7 8 9 10 11
ti19407a
THIN
MATERIAL
THICK
MATERIAL
ti19353a
ti19408a
ti19409a