Filter
Top Products
Repair
3A2308C 31
Pump Module/Drive Module
Removal
1. Engage trigger lock and put prime/pressure relief
valve in UP position to relieve pressure.
2. Remove material cup and battery.
3. Unscrew swivel bolt (22) by pressing down and
turning it counter-clockwise. Use tool if needed.
4. Unscrew bolt (20). Use tool if needed.
5. Remove pump module (35) from drive module (11).
Installation
1. Engage trigger lock and remove battery from unit.
2. Assemble pump module (35) to drive module (11).
Gears must properly engage for assembly. Slightly
rotate pump assembly as needed for proper
engagement.
3. Assemble swivel bolt (22) and bolt (20). Partially
thread both bolts before tightening either bolt. Use
tool to tighten and make sure bolts are secure.
NOTE: Make sure there is no gap between the two
housings when assembling bolts.
ti19350a
ti19347a
ti19360a
ti19617a
ti19621a
22
ti19618a
20
ti19625a
35
11
ti19350a
ti19617a
ti19624a
35
11
ti19622a
22
20