Filter
Top Products
308253 7
Operation
Dispensing
1. Start the fluid supply pump.
2. The fluid flow rate is controlled at the pump. Adjust
the pump pressure to obtain the desired flow rate.
It is recommended that you use the lowest pres-
sure necessary to dispense the fluid. The pressure
adjustment will depend on the hose length, the
viscosity of the fluid, and the gun nozzle size.
3. Unlock the gun trigger safety.
4. Squeeze the trigger in all the way. Fluid flow
begins with the slightest pressure on the trigger
and stops when the trigger is released.
NOTE: Periodically inspect the vent in the gun handle
for fluid buildup which could indicate an internal leak.
See Fig. 3. Service the fluid tube and o-ring as
needed.
Fig. 3
01807A
Vent
Flushing Safety
WARNING
FIRE AND EXPLOSION HAZARD
To reduce the risk of a fire, explosion, or
serious injury,
D Be sure the entire system and flush-
ing pails are properly grounded
before flushing the gun or system.
Read Grounding the System, on page 5.
D Use the lowest possible fluid pressure and
maintain firm metal-to-metal contact between
the gun and the grounded metal pail during
flushing.