Filter
Top Products
Setup
3A0159E 11
Sprayer Setup
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material or any storage fluid from
the sprayer before using it.
1. Plug sprayer into a properly-grounded outlet.
2. Fill material cup with water and thread onto sprayer.
3. Put control lever to UP position, then hold trigger in
for 10 seconds.
4. Put control lever DOWN to spray position.
5. Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area.
6. Engage trigger lock and put control lever UP to
release pressure.
7. Unscrew and remove material cup.
8. Disengage trigger lock, put control lever DOWN,
hold sprayer slightly above material cup, and pull
trigger to discharge fluid from pump.
9. Discard material in the cup.
ti14992a
ti14999a
ti15425a
ti14991a
ti15491a
ti14999a
ti14994a
ti15478a