Filter
Top Products
Install Tip/Guard Assembly (if not installed)
3A0159E 13
Install Tip/Guard Assembly
(if not installed)
Reversible Tip Selection Chart
1. Engage trigger lock and put control lever UP to release
pressure in the sprayer.
2. Install filter to Spray Tip/Guard Assembly. Make sure
filter is fully installed into sprayer. NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
3. Firmly screw Tip/Guard Assembly onto sprayer.
Tighten retaining nut until completely engaged with
sprayer. If Tip/Guard Assembly is not fully tightened,
poor spray results and possible damage to the sprayer
could occur.
Shoulder Strap Installation
1. Attach the metal eyelet to the back of the sprayer.
2. Open the velcro end of the strap, then route it through
the slot under the tip of the sprayer.
3. Route velcro up through the metal triangle, then fold
down and attach velcro to strap.
MATERIALS
*Thin Medium Heavy
Thin stains,
semi-transparent stains
Enamels, solid
stains, thin latex
Heavy latex
311 315, 515 517
*For thin materials install Fine-Finish Optimizer, page 10.
NOTE: Spraying thicker materials with a 311 tip may cause the
motor to overheat. Use the Reversible Tip Chart to determine
the correct tip for your application. If motor does overheat, allow
sprayer to cool for 20-30 minutes before operating.
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid splattering material or damage to the
filter.
ti14999a
ti14994a
ti14775a
ti14997a
NOTICE
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.