Filter
Top Products
Install Tip/Guard Assembly (if not installed)
3A0705E 11
Install Tip/Guard Assembly
(if not installed)
Reversible Tip Selection Chart
1. Engage trigger lock and put prime/relief valve UP to
release pressure. Then remove Tip/Guard Assembly.
2. Install filter to Spray Tip/Guard Assembly (make sure
filter is fully installed into sprayer). NOTE: Filter assem-
bly is reverse-threaded. Turn left (or counter-clock-
wise) to install. Turn right (or clockwise) to remove.
3. Firmly screw Tip/Guard Assembly onto sprayer.
Tighten retaining nut until completely engaged with
sprayer. If Tip/Guard Assembly is not fully tightened,
poor spray results and possible damage to the sprayer
could occur.
MATERIALS
*Thin Medium Heavy
Thin stains,
semi-transparent stains
Enamels, solid
stains, thin latex
Heavy latex
311 315, 515 517
*Install Fine-Finish Optimizer, see page 8.
ti14999a
ti14994a
NOTICE
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid splattering material or damage to the
filter.
NOTICE
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.
ti14775a
ti15490a