Filter
Top Products
Basic Spraying Techniques
12 3A0705E
Basic Spraying Techniques
NOTE: Use a piece of scrap cardboard to practice these
basic spraying techniques before you begin spraying the
surface. Anything you don’t want painted that is in
the area of your spraying surface should be covered
or removed.
Hold sprayer at least 25 cm (10 in.) from surface and
adjust accordingly to achieve desired results. Aim
sprayer straight at surface. Tilting sprayer to direct spray
angle causes an uneven finish.
Flex your wrist while moving your arm to keep the
sprayer pointed straight. Tilting the sprayer or spraying
at an angle causes an uneven finish.
NOTE: How fast you move the sprayer will affect spray
application. If material is pulsating, you are moving too fast.
If material drips, you are moving too slow. See Trouble-
shooting, page 18.
Triggering Sprayer
Pull trigger after starting stroke. Release trigger before end
of stroke. Sprayer must be moving when trigger is pulled
and released.
Aiming Sprayer
Aim tip of sprayer at bottom edge of previous stroke, over-
lapping each stroke by half.
10 in.
(25 cm)
even
finish
thick
thin
uneven
finish
ti14780a
even finish thin thick thin
ti14986a
ti14987a
ti14988a
Start Moving Pull Trigger Release Trigger
ti14782a