Filter
Top Products
Setup
10 3A1456D
Materials
NOTE: When spraying water-based materials, flush the
sprayer thoroughly with water.
Starting a New Job (or Refilling the Cup)
1. Engage trigger lock and put prime/relief valve UP to
release pressure.
2. Use the Fine-Finish Optimizer cleaning tool to lightly
push on inlet valve to make sure it moves up and
down freely.
3. Install material cup liner, fill with material, and
thread onto sprayer.
4. To prime pump, disengage trigger lock and trigger
sprayer for 10 seconds. Then release trigger and
put prime/relief valve DOWN to spray position.
5. Reverse spray tip to UNCLOG position and spray
into waste area for five seconds. Then rotate tip
back to SPRAY position. NOTE: Failure to perform
this operation could result in poor spray pattern.
NOTE: If sprayer fails to prime, follow Alternative
Priming Method (page 19) and/or Inlet Valve
Cleaning (page 20).
Use only water-based materials. Do not use materi-
als which state “FLAMMABLE” on the packaging. For
more information about your material, request MSDS
from distributor or retailer.
Spraying certain materials may cause static
build-up in the sprayer that can result in static
shock to the user. If this occurs, first ensure the mate-
rial has a flash point greater than 100° F (38° C) and
does not state that it is FLAMMABLE anywhere on the
package. If still feeling a static shock, the material likely
contains a non-mineral spirits fluid such as, but not lim-
ited to, xylene, toluene, or naphtha, which can build up
static. Switch to an alternative material.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
ti14999a
ti14994a
ti15474a
ti15418a
ti15425a
ti14995a