Filter
Top Products
Troubleshooting
3A1456D 23
Spray pattern is too narrow:
Sprayer is too close to target surface.
Incorrect tip for application of material.
Tip is worn or damaged.
Move sprayer away from surface (10 in).
See Reversible Tip Selection Chart, page 11.
Replace tip. See Install Tip/Guard Assembly,
page 11.
Spray pattern is too wide: Sprayer is too far away from target surface.
Incorrect tip for application of material.
Move sprayer closer to surface.
See Reversible Tip Selection Chart, page 11.
Spray pattern “spits” at the end: Excess material has accumulated on Spray
Tip/Guard Assembly.
Tip filter is partially clogged.
Tip/Guard Assembly not threaded com-
pletely onto sprayer.
Seat is worn.
See Shutdown and Cleaning, page 14.
Clean or replace filter. See page 13.
See Install Tip/Guard Assembly, page 11.
Replace Spray tip.
Tip continues to drip or ooze
material after trigger is
released:
Sprayer is worn out. Replace sprayer.
Spray pattern does not
adequately cover target
surface
Fine Finish Optimizer is installed while using
an incompatible material.
Sprayer is worn out.
Make sure compatible material is being used.
See Reversible Tip Selection Chart, page 11.
Replace sprayer.
Problem Cause Solution
ti15523
ti15527a
ti15525a
ti15528a