Filter
Top Products
Warning
309295N 5
Skin Injection Hazard
Spray from the gun, hose leaks, or ruptured components can inject fluid into your body and cause
an extremely serious injury, including the need for amputation. Splashing fluid in the eyes or on the
skin can also cause serious injury.
• Fluid injected into the skin might look like just a cut, but is a serious injury. Get immediate
surgical treatment.
• Do not point the gun at anyone or at any part of the body. Do not put your hand or fingers over
the spray tip. Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
• Never spray without the tip guard in place.
• Lock the trigger safety when you stop spraying.
• Follow the Pressure Relief Procedure, page 24, when you stop spraying and before cleaning,
checking, or repairing equipment.
• Check the hoses and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
• Tighten all fluid connections before each use.
Toxic Fluid Hazard
Hazardous fluids or toxic fumes can cause a serious injury or death if splashed in the eyes or on
the skin, swallowed, or inhaled.
• Know the specific hazards of the fluid you are using. Read the fluid manufacturer’s warnings.
• Store hazardous fluid in an approved container. Dispose of the hazardous fluid according to all
local, state, and national guidelines.
• Wear appropriate protective clothing, gloves, eyewear, and respirator.
Equipment Misuse Hazard
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and
result in a serious injury.
• This equipment is for professional use only.
• Read all manuals, tags, and labels before operating the equipment.
• Use the equipment only for its intended purpose. If you are uncertain, call your Graco
distributor.
• Do not alter or modify equipment. Use only genuine Graco parts and accessories.
• Check the equipment daily. Repair or replace worn or damaged parts immediately.
• Do not exceed the maximum working pressure of the lowest rated system component.
Maximum working fluid pressure of this equipment is 3000 psi (21 MPa, 210 bar).
• Use fluids and solvents that are compatible with the equipment wetted parts. See the
Technical Data section of all equipment manuals. Read the fluid and solvent manufacturer’s
warnings.
• Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180°F (82°C) or below -40°F (-40°C).
• Wear hearing protection when operating this equipment.
• Comply with all applicable local, state, and national fire, electrical, and other safety
regulations.
WARNING