Filter
Top Products
Daily Gun Care, Flushing, and Cleaning
311001G 15
4. Connect the solvent supply hose (T) to the gun.
5. Increase the pressure slowly. Point the gun down
into a grounded metal container, and flush the gun
with solvent until all traces of fluid are removed from
the gun passages.
6. Turn off the solvent supply.
7. Relieve the pressure.
8. Disconnect the solvent supply hose (T) from the
gun.
9. If it is necessary to remove the diffuser (5) to clean,
trigger the gun while you remove the diffuser with
the gun tool (30).
10. Dip the end of a soft-bristle brush into a compatible
solvent. Do not continuously soak the brush's bris-
tles with solvent and do not use a wire brush.
11. With the gun pointed down, clean the front of the
gun, using the soft-bristle brush and solvent.
12. Scrub the air cap retaining ring (6), air cap (21), dif-
fuser (5), and spray tip (33) with the soft-bristle
brush. To clean out air cap holes, use a soft tool,
such as a toothpick, to avoid damaging critical sur-
faces. Blow air through the spray tip to ensure the
orifice is clean. Clean the air cap and spray tip daily,
minimum. Some applications require more frequent
cleaning.
F
IG. 19
F
IG. 20
F
IG. 21
TI6557A
T
TI6729A
TI6566A
T
CAUTION
Trigger the gun whenever you tighten or remove the
diffuser (5). This keeps the needle ball away from the
seating surface and prevents the seat from being
damaged.
F
IG. 22
F
IG. 23
TI4845A
TI6569A