Filter
Top Products
Setup
312001R 11
Setup
1. Unscrew tip and guard
assembly from gun.
2. Uncoil hose and connect
one end to gun. Use two
wrenches to tighten
securely
3. Connect other
end of hose to
sprayer.
NOTE: If hose is already connected, make sure
connections are tight.
4. Turn OFF power switch.
5. Turn Pressure Control
Knob all the way left
(counter-clockwise) to
minimum pressure.
Prime and Flush Storage Fluid
NOTE: To spray lacquers with the ProX7 or ProX9,
you must purchase lacquer conversion kit 256212,
and follow priming procedure for oil-based materi-
als. The X5 and X7 units are not intended for lac-
quers.
Before you use your sprayer for the first time or be-
gin a new spraying project, you need to prime the
sprayer and flush the storage fluid out of the spray-
er.
Oil- or Water-based Materials
• When spraying water-based materials, flush
the system thoroughly with water.
• When spraying oil-based materials, flush the
system thoroughly with mineral spirits or com-
patible, oil-based flushing solvent.
•To spray water-based materials after spray-
ing oil-based materials, flush the system thor-
oughly with water first. The water flowing out of
prime tube should be clear and solvent-free
before you begin spraying the water-based
material.
•To spray oil-based materials after spraying
water-based materials, flush the system thor-
oughly with mineral spirits or a compatible
oil-based flushing solvent first. The solvent
flowing out of the prime tube should not contain
any water.
• When flushing with solvents, ground pail and
gun. Read Grounding and Electric Require-
ments, page 7.
• To avoid fluid splashing back on your skin or
into your eyes, always aim gun at inside wall of
pail.
ti9714a
ti9681a
ti9674b
(ProX7 & ProX9)
ti11456a
(X5 & X7)
ti2810a
ti9344a