Filter
Top Products
DataTrak Controls and Indicators
313255K 19
DataTrak Controls and Indicators
Key for FIG. 8
AA Runaway Limit, in cycles per minute (user settable;
00=OFF)
AB Lower Displacement (user settable)
AC Flow Rate Units (user settable to gpm [US], gpm
[Imperial], oz/min [US], oz/min [Imperial], l/min, or cc/min)
AD LED (fault indicator when lit)
AE Display
PF Prime/Flush Key (Enables Prime/Flush mode. While in
Prime/Flush mode, runaway protection is disabled and the
batch totalizer [BT] will not count.) LED will flash while in
Prime/Flush mode.
RK Reset Key (Resets faults. Press and hold for 3 seconds to
clear the batch totalizer.) Push to toggle between flow rate
and cycle rate. With runaway protection enabled, push to
extend and retract the solenoid pin.
CF Cycle/Flow Rate
BT Batch Totalizer
GT Grand Totalizer
RT Runaway Toggle (enable/disable)
UT E1 Toggle
DT E2 Toggle
ST E5 Toggle
/min,
FIG. 8. DataTrak Controls and Indicators
AD
AE, see details at right
CF BT
GT
AC
RT
AA
PFRK
AB
UT
DT
ST
Run Mode
Setup Mode
ti11883a
RK
PF
ti8622b
ti8623b