Digital Tracking System (Not Available on All Units)
3A0156B 15
Secondary Menu - Stored Data and
WatchDog Pump Protection Modes
1. Perform Pressure Relief, steps 1 - 4 if they have
not already been done.
2. Turn power switch on while holding DTS button
down.
3. SERIAL NUMBER scrolls past and then serial num-
ber (e.g. 00001) displays.
4. Short press DTS button and MOTOR HOURS
scrolls past and then total motor run hours are dis-
played.
5. Short press DTS button. LAST ERROR CODE
scrolls by and last error code is displayed; e.g. E=07
(see Repair manual).
6. Press and hold DTS button to clear error code to
zero.
7. Short press DTS button. W-DOG scrolls past then
OFF displays if watchdog switch is OFF. ON dis-
plays if Watchdog switch is ON.
8. Press and hold (8 seconds) DTS button to move to
WatchDog Trigger % menu. Continue to hold DTS
button and Watchdog can be set to trigger at 30, 40,
50, or 60% of current sprayer pressure setting.
Release DTS button when desired % is displayed.
Default is 50%.
9. Short press to move to SOFTWARE REV.
10. Short press DTS button. MOTOR ID RESISTOR
scrolls by and model code number (see below).
ti4266a
ti13605a
ti7362a
ti13622a
ti13618a
ti13619a
ti13601a
ti13615a
ti13607a
ti13609a
ti13606a
Code Number Models
0695
2 795 / MARK IV
4 1095 / 220V MARK V
6 1595 / 120V MARK V
ti13608a
ti13626a
ti13614a
TIA
ti13613a
ti13623a