Compressor and Motor Repair
310645S 15
8. Loosen 2 shoulder
bolts about 2-3 turns.
Do not remove them.
9. Remove single shoul-
der bolt on other side
of motor completely.
10. Slide out motor
assembly.
11. Completely remove
old shoulder bolts and
rubber mounts.
12. Thoroughly clean inside housing to remove dust
and debris.
Reassembly
1. Using two new shoulder
bolts and rubber mounts
included in your kit, insert
bolts into openings until
they start to snug up on
rubber mounts.
2. Slide new motor into
sprayer frame, aligning
motor frame opening
under bolts. Tighten
bolts.
3. Replace shoulder
bolt on left side with
new bolt from your
kit. Tighten bolt.
4. Replace end cover.
Replace and tighten 3
screws.
5. Reattach air line to
cooler and compressor.
Tighten fitting.
6. Slide belt over pulleys
and set tension. See
Replacing Belt, page 19.
ti4463a
ti4425a
ti4462a
ti4464a
ti4465a
ti4468a
ti4424a
ti4484a
ti4485a
ti4516a