Filter
Top Products
Digital Tracking System (ProContractor and Ironman units)
18 332919C
Secondary Menu - Stored Data and
WatchDog Pump Protection Modes
1. Perform Pressure Relief, steps 1 - 4 if they have
not already been done.
2. Turn power switch on while holding DTS button
down.
3. The sprayer model briefly displays (e.g. 5900),
SERIAL NUMBER scrolls past and then serial num-
ber (e.g. 00001) displays.
4. Short press DTS button and MOTOR ON scrolls
past and then total motor run hours are displayed.
5. Short press DTS button. LAST ERROR CODE
scrolls by and last error code is displayed; e.g.
E=07. See sprayer Repair manual for additional
information.
6. Press and hold DTS button to clear error code to
zero.
7. Short press DTS button. W-DOG scrolls past then
OFF displays if watchdog switch is OFF. ON dis-
plays if Watchdog switch is ON.
8. Press and hold (8 seconds) DTS button to move to
WatchDog Trigger % menu. Continue to hold DTS
button and Watchdog can be set to trigger at 30, 40,
50, or 60% of current sprayer pressure setting.
Release DTS button when desired % is displayed.
default is 50%.
9. Short press to move to SOFTWARE REV.
ti22719a
ti22720a
ti22721a
ti22722a
ti22723a
ti22724a
ti22725a
ti22726a