Filter
Top Products
3308–367
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment
misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result
in a serious injury
.
D
This equipment is for professional use only
.
D
Read all the instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check the equipment daily
. Repair or replace worn or damaged parts immediately
.
D
Do not exceed the maximum working pressure of the lowest rated system component. This equip
-
ment has a 2760 psi (19.0 MPa, 190 bar) maximum fluid working pressure at 120 psi (0.84
MPa, 8.4 bar) incoming air pressure.
D
Use fluids that are compatible with the equipment wetted parts. See the
T
echnical Data
section of
all the equipment manuals. Read the fluid manufacturer
’
s warnings.
D
Route the hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180
_F (82_
C) or below –40
_F (–40_C).
D
Comply with all applicable local, state, and national fire, electrical, and other safety regulations.
FIRE AND EXPLOSION HAZARD
Improper
grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury
.
D
Ground the equipment and object being sprayed. See
Grounding
on page 5.
D
Provide fresh air ventilation avoid the buildup of flammable fumes from solvent or the fluid being
sprayed.
D
Extinguish all the open flames or pilot lights in the spray area.
D
Electrically disconnect all the equipment in the spray area.
D
Keep the spray area free of debris, including solvent, rags, and gasoline.
D
Do not turn on or of
f any light switch in the spray area while operating or if fumes or present.
D
Do not smoke in the spray area.
D
Do not operate a gasoline engine in the spray area.
D
If there is any static sparking while using the equipment,
stop spraying immediately
. Identify and
correct the problem.