Filter
Top Products
10 308-236
Service
7.
Slide the rear of the needle (2c*) into the front of
the gun. Slide the tool (B), provided with the repair
kit, into the gun, around the needle. Lightly tap the
tool with a hammer or lightly press the tool against
a flat surface to seat the needle. See Fig. 9.
Remove the tool.
CAUTION
T
apping or pressing the tool too hard may jam the
tool and damage the needle.
8.
Grease the end of the needle.
9.
Grease the dif
fuser/seat threads. Place the new
gasket (2b*) on the dif
fuser/seat (2a*) and screw
the assembly into the fluid housing (6). T
orque to
20–25 ft-lb (27–34 N.m). See Fig. 10.
10.
Install the trigger (8), pivot pin (10) and screw (12).
See Fig. 10.
NOTE:
No needle or trigger adjustment is needed.
Fig. 9
2c
02354
B
Fig. 10
8
2a*
2b*
12
10
Lubricate,
then torque
to 20–25 ft–lb (27–34 N.m)
1
1
02352
6