Filter
Top Products
14 309273
PAINT
FLUSH
FLUSH
14.Raise siphon tube above flushing fluid
and run sprayer for 15 to 30 seconds to
drain fluid. Turn power OFF.
15.Make sure plastic center tube is tightened
securely. Install filter bowl and filter. Hand
tighten filter bowl. Install filter assembly
into gun. Hand tighten gun handle.
16.Wipe sprayer, hose and gun with a rag
soaked in water or mineral spirits.
Note: If flushing with water, flush again with mineral spirits or Pump
Armor, but do not repeat 8. or 14. This leaves a protective
coating in the system to help prevent freezing or corrosion.
17.Clean tip, guard and gasket with a soft
bristle brush to prevent part failure due
to dried materials. Assemble parts and
attach loosely onto gun.