Graco Inc. GC-1412 Paint Sprayer User Manual


  Open as PDF
of 32
 
GC-1412D 21
SSP-160-01
If you are using the optional Formula gun set the
trigger air regulator to 100 PSI (7 bar). The trigger
air IS NOT to exceed 100 PSI (7 bar).
10. Trigger the Gun into a container until all the air is
purged from the resin side of the system. It may be
QHFHVVDU\WR+DQGVWURNHWKH&DWDO\VW3XPS
several times while the gun is triggered to positively
deliver a steady stream of catalyst. Let go of the
WULJJHUDQGKDQGVWURNHSXPSDJDLQWRGHYHORS
300-400 PSI (21-28 bar). “STOP”
a.6ROYHQWÀXVKWKHJXQ³6723´
E Once primed, increase the resin PSI until a desired
spray pattern is achieved.
c. After all pressure adjustments have been completed, a
¿QDOVSUD\WHVWVKRXOGEHPDGH6SUD\DWHVWVKRW
sample on a clean piece of paper. The shot should be
DSSUR[LPDWHO\¿YHIHHWLQOHQJWK<RXFDQQRZFKHFN
desired gel times and uniformity of curing.
d. Flush the gun thoroughly with solvent after use.
11. 0DNHVXUHWKDWWKHUHVLQSXPSUHFLUFXODWLRQYDOYH
LV³RII´DQGWKDWWKHE\SDVVKRVHLVLQEDFNLQWKH
the drum. Adjust the resin pump regulator to 20 PSI
(1.4 bar) the pump will start to slowly cycle. Allow the
pump to “load” the cycle rate should slow indicating the
pump is primed. Close the recirculation valve.
Recirculation Valve
Resin Pump Regulator
Do not exceed 20 PSI (1.4 bar) pressure on the Material
5HJXODWRUXQWLOVWHDG\PDWHULDOÀRZKDVEHHQHVWDEOLVKHG
E Turn the slave pump
yellow ball valve to the
open position.
c. Hand prime the pump
until a steady stream of cat-
DO\VWÀRZVEDFNWRWKHERWWOH
d. Close the ball valve. Hand
VWURNHWKHSXPSXQWLOLWGHYHO
opes 300-400 PSI (21-28 bar).
9a. Pull and rotate Pivot
NQREWRGLVHQJDJHWKHFDWDO\VW
drive arm.
Start-Up
 previous next