Filter
Top Products
Installation
309292S 11
4. Remove the fluid tube and fittings.
5. Remove the fluid inlet bracket.
6. Install the new bracket (3) from the kit loosely. See
F
IG. 3.
7. Place the spacer (5) in the barrel inlet. Apply Graco
dielectric grease (4) to the o-rings (2a, 2b) and to
both threads of the fluid fitting (2). Thread the fitting
into the barrel inlet.
8. Thread the nut (1d) onto the fitting (2). Make sure
the ferrules (1c and 1b) are on the tube (1a) and are
seated on the fitting (2) before tightening the nut
(1d).
9. Slide the tube case (1e) onto the barrel inlet, over
the o-ring (2b). The coiled tube (1a) will compress
slightly.
10. Insert the end of the coiled tube (1a) into the bracket
(3). Make sure the ferrules (1c, 1b) seat on the
bracket.
11. Secure the bracket by tightening the swivel (A).
Tighten the nut (1d). Reinstall the exhaust tube (B)
and clamp (C).
12. Reconnect the fluid and air lines to the gun.
F
IG. 3: 244919 Conversion Kit
1a
1e
5
2a
2b
2
1b
1c
1d
1e
1e
1e
1e
C
B
3
A
ti10674a