Filter
Top Products
-16-
G0527 18" Wide Belt Sander
To hook up the air line:
1. Connect the hose from your air compressor
to the air inlet (Figure 7) on the regulator.
2. Make sure the red handle on the regulator is
in the open position (parallel with the air
inlet).
3. Lift the black regulator knob (Figure 7) and
adjust it until the air pressure gauge reads 75
PSI. Note—Turn the dial clockwise to
increase the air pressure and counterclock-
wise to lower the air pressure.
4. Push the regulator knob down until it snaps.
Figure 7. Air inlet located on regulator.
Dust CollectionAir Line Hook-Up
Figure 8. Dust collection hook-up.
An efficient and clean dust collection system is
essential to the proper function of the sander.
Ensuring a healthy work environment is also
dependent upon cleaning and maintaining your
dust collection system.
To hook up the dust collection system:
1. Install the 4" dust port (Figure 8) on the
mounting locations at the top of the sanding
unit with the supplied M6-1.0 x 10 phillips
head screws.
2. Clamp a hose from your dust collection sys-
tem to the dust port.
Air Inlet
Red Handle
(Closed Position)
Black
Regulator
Knob