Filter
Top Products
-6-
G0527 18" Wide Belt Sander
The Model G0527 has three motors that are
wired to operate on a 220V single-phase power
source. They will draw the following loads:
Sanding Drum Motor ............................30 Amps
Conveyor Feed Motor ..........................3.8 Amps
Elevation Motor ......................................3 Amps
Use the following guidelines when choosing a cir-
cuit breaker (circuit breakers rated any higher are
not adequate to protect the circuit):
Circuit Breaker............................40 Amp, 2 Pole
Always check to see if the wires in your circuit are
capable of handling the amperage load from your
machine. If you are unsure, consult a qualified
electrician.
If you operate this machine on any circuit that is
already close to its capacity, it might blow a fuse
or trip a circuit breaker. However, if an unusual
load does not exist and a power failure still
occurs, contact a qualified electrician or our
Service Department at (570) 546-9663.
Circuit Capacity
Figure 1. Locking shut-off lever.
Connection Type
Circuit Breaker
Amperage Draw
Because of the high amperage draw from this
machine, we recommend that you hardwire it
directly to your circuit breaker and install a lock-
ing shut-off lever (Figure 1) near the machine as
a way to quickly disconnect the power.
SECTION 3: CIRCUIT REQUIREMENTS