Filter
Top Products
-14- G1028Z/G1029 Dust Collector
Figure 10. Tightening steel band.
3. Slip the steel band around the bag and tight-
en down as shown in Figure 10.
Inlet
Press the “Y” inlet onto the inlet cover flange as
shown in Figure 11. The inlet is secured to the
collector body by a press-on fit.
Figure 11. Installing “Y” inlet.
4. Slip the bottom collection bag over the bot-
tom edge of the collector and pull the strap
tight to secure the bag.
5. Place the steel band with the quick clamp
over the bag and clamp on the tightest notch
possible.
DO NOT force the clamp. Instead, choose
the next notch over, then clamp in place.